Zoobird

Dangerously organic!


I just descaled my new (used) unit and checked the temperature. You can see the readings in the photos I took by clicking here. The steam wand was about 140F and the espresso water was a little over 160F. Is that OK?

Views: 106

Replies to This Discussion

Hello Michael,

Edward Harris, from PartsGuru.com would be the person to accurately answer this question; he's the specialists.

However, on my Saeco, Via Veneto, a similar machine to the Gaggia, Espresso the espresso water temperature is about the same (162F). But, on the steam side, the temperature actually will increase if it's allowed to run for a length of time. I think this is because it takes the steam generator time to get up to full operating temperature.

When Edward gets on this blog, I expect he will fully give you all of the details and specifics.

Regards,

Ken
Temperature readings from both outlets of water are low.
Possible solutions include in the order stated below:
1- Replace water thermostat Limit 107C
2- Check resistance on the heating element. If it is below 14 Ohms, replace the boiler.
Good luck.
Edward
Thanks, Ed. I'll order a thermostat and check the resistance on the heating element. Onward to great espresso!
Ed,

Would you be so kind as to send the water thermostat you suggested to me for my Espresso and charge it to my account? In the meantime, I'll check the resistance. Thanks,

Mike

RSS

About

Michael Levin created this Ning Network.

Translate Zoobird

The Zoobird Bookshelf

Click here to visit the Zoobird Bookshelf

 

Your donation helps to support this website!

 

Zoobird

Promote Your Page Too

 

Reading List

Badge

Loading…

Show your colors!

© 2024   Created by Michael Levin.   Powered by

Badges  |  Report an Issue  |  Terms of Service